Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
378
47
LOOPBACK DETECTION COMMANDS
The Loopback Detection commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command Parameters
config loopdetect { recover_timer [ 0 | <value 60-1000000> ] | interval < value 1-32767> | mode [ port-based |
vlan-based ] } (1)
config loopdetect ports [ <portlist> | all ] state [ enable | disable ]
enable loopdetect
disable loopdetect
show loopdetect
show loopdetect ports [ <portlist> | all ]
config loopdetect trap [ none | loop_detected | loop_cleared | both ]
Each command is listed, in detail, in the following sections: