Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
145
16
VLAN COMMANDS
The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table:
Command Parameters
create vlan <vlan_name 32> tag <vlanid 1-4094> {advertisement}
delete vlan <vlan_name 32> | vlanid <vidlist>
create vlan vlanid <vidlist> {advertisement}
delete vlan vlanid <vidlist>
config vlan vlanid <vidlist> { [ add [ tagged | untagged | forbidden ] | delete ]
<portlist> | advertisement [ enable | disable ] | name <vlan_name
32>} (1)
config vlan <vlan_name 32> {[add [tagged | untagged | forbidden] | delete]
<portlist> | advertisement [enable | disable]} (1)
enable pvid auto_assign
disable pvid auto_assign
show pvid auto_assign
config gvrp [<portlist> | all] {state [enable | disable] | ingress_checking [enable
| disable] | acceptable_frame [tagged_only | admit_all] | pvid
<vlanid 1-4094>} (1)
enable gvrp
disable gvrp
show vlan {[<vlan_name 32> | vlanid <vidlist> | ports <portlist>]}
show gvrp {<portlist>}
Each command is listed, in detail, in the following sections:
create vlan
Purpose
Used to create a VLAN on the Switch.
Syntax
create vlan <vlan_name 32> tag <vlanid 1-4094> {advertisement}
Description
This command allows the user to create a VLAN on the Switch.
Parameters
<vlan_name 32> − The name of the VLAN to be created.
<vlanid 1-4094> − The VLAN ID of the VLAN to be created. Allowed
values = 1-4094
advertisement − Specifies that the VLAN is able to join GVRP. If
this parameter is not set, the VLAN cannot be configured to have
forbidden ports.
Restrictions
Each VLAN name can be up to 32 characters. Up to 4094 static
VLANs may be created per configuration. Only Administrator-level
users can issue this command.
Example usage:
To create a VLAN v1, tag 2: