Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
380
config loopdetect ports
Purpose
Used to configure the loopback detection function for the port on the Switch.
Syntax
config loopdetect ports [ <portlist> | all ] state [ enable | disable ]
Description
This command is used to set up the loopback detection function for port configuration on the
Switch.
Parameters
<portlist> – Specifies a range of ports to be configured for loopback detection status.
all – Apply setting to all ports.
state - Allows loopback detection to be enabled or disabled for the ports specified in the port list.
The default is disabled.
enable – Set port loopback detection status to enable.
disable - Set port loopback detection status to disable.
Restrictions
Only Administrator-level users can issue this command.
Example usage
To set the loopback detection status to enabled:
DES-3200-28F:4# config loopdetect ports 1-5 state enable
Command: config loopdetect ports 1-5 state enable
Success.
DES-3200-28F:4#