Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
453
DES-3200-
28F:4# config ethernet_oam ports 1 link_monitor error_symbol threshold 2 window 1000
notify_state enable
Commands: config ethernet_oam ports 1 link_monitor error_symbol threshold 2 window 1000
notify_state enable
Success
DES-3200-28F:4#
config ethernet_oam ports (link monitor error frame)
Purpose
Used to configure Ethernet OAM link monitoring error frame configuration for ports.
Syntax
config ethernet_oam ports [<portlist> | all ] link_monitor error_frame { threshold <number> |
window < milliseconds 1000-60000> | notify_state [enable | disable ] } (1)
Description
The command used to configure Ethernet OAM link monitoring error frames for ports.
Link monitoring function provides a mechanism to detect and indicate link faults under a variety
of conditions. OAM monitors the counts of the number of frame errors as well as the number of
coding symbol errors. When the number of frame errors is equal to or greater than the
specified threshold in a period and the event notification state is enabled, it generates an error
frame event to notify the remote OAM peer.
Parameters
<portlist> - Specifies a range of ports to be configured. Use all to specify all ports.
threshold - Specify the number of frame errors in the period that must be equal to or greater
than in order for the event to be generated. The default value is 1 frame error.
window - The range is 1000 to 60000 ms. The default value is 1000ms.
notify_state - Specify to enable or disable event notification. The default state is enable.
Restrictions
Only Administrator-level users can issue this command.
Example usage
To configure the error frame threshold to 2 and period to 1000 ms for port 1:
DES-3200-28F:4# config ethernet_oam ports 1 link_monitor error_frame thresh
old 2 window 1000
notify_state enable
Commands: config ethernet_oam ports 1 link_monitor error_frame threshold 2 window 1000
notify_state enable
Success
DES-3200-28F:4#
config ethernet_oam ports (link monitor error frame seconds)
Purpose
Used to configure Ethernet OAM link monitoring error frame seconds configuration for ports.
Syntax
config ethernet_oam ports [<portlist> | all ] link_monitor error_frame_seconds