xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
447
DES-3200-28F:4# show cfm remote_mep mepname mep1 remote_mepid 2
Command: show cfm remote_mep mepname mep1 remote_mepid 2
Remote MEPID : 2
MAC Address : 00-11-22-33-44-02
Status : OK
RDI : Yes
Port State : Blocked
Interface Status : Down
Last CCM Serial Number : 1000
Sender Chassis ID : 00-11-22-33-44-00
Sender Management Address : SNMP-UDP-IPv4 10.90.90.90:161
Detect Time : 2008-01-01 12:00:00
DES-3200-28F:4#
show cfm pkt_cnt
Purpose
This command is used to show the CFM packet’s RX/TX counters.
Syntax
show cfm pkt_cnt { [ ports <portlist> { [ rx | tx ] } | [ rx | tx ] | ccm ] }
Description
CFM packet counters will be shown.
Parameters
ports <portlist> - Specifies the port counters to show. If not specified, all ports will be shown.
{[rx | tx]} - Show RX or TX counter. If not specified, both of them will be shown.
[rx | tx] - Show RX or TX counter.
Ccm - CCM RX counters.
Restrictions
None.
Example usage
To display the CFM packet counters on ports 1-12:
DES-3200-28:4#show cfm pkt_cnt ports 1-12
Command: show cfm pkt_cnt ports 1-12
CFM RX Statistics
-----------------------------------------------------------------------
Port AllPkt CCM LBR LBM LTR LTM
----- ---------- ---------- ---------- ---------- ---------- ----------
all 696 696 0 0 0 0
1 0 0 0 0 0 0
2 696 696 0 0 0 0
3 0 0 0 0 0 0
4 0 0 0 0 0 0
5 0 0 0 0 0 0
6 0 0 0 0 0 0
7 0 0 0 0 0 0
8 0 0 0 0 0 0
9 0 0 0 0 0 0
10 0 0 0 0 0 0
11 0 0 0 0 0 0
12 0 0 0 0 0 0