Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
384
config loopdetect trap
Purpose
Used to configure loopback detection traps.
Syntax
config loopdetect trap [ none | loop_detected | loop_cleared | both ]
Description
This command is used to specify the trap modes for loop detection.
Parameters
none – A trap is not sent in either case.
loop_detected - Trap is sent when the loop condition is detected.
loop_cleared - Trap is sent when the loop condition is cleared.
both – A trap is sent in either case.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To set trap mode for loopback detection:
DES-3200-28F:4# config loopdetect trap both
Command: config loopdetect trap both
Success.
DES-3200-28F:4#