Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
82
10
NETWORK MONITORING COMMANDS
The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table:
Command Parameters
show packet ports <portlist>
show error ports <portlist>
show utilization [cpu | dram | flash | ports {<portlist>}]
clear counters {ports <portlist>}
clear log
show log {index <value_list X-Y>}
enable syslog
disable syslog
show syslog
create syslog host <index 1-4> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number>| ipaddress [<ipaddr>] | state [enable |
disable] }
config syslog {host [all | <index 1-4>]} {severity [informational | warning | all] |
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <udp_port_number> | ipaddress [<ipaddr>] |
state [enable | disable]}
delete syslog host [<index 1-4> | all]
show syslog host {<index 1-4>}
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
show log_save_timing
delete ipif [System] [ipv6adress <ipv6networkaddr>]
enable
ipif_ipv6_link_local_auto
[System]
disable
ipif_ipv6_link_local_auto
[System]
show
ipif_ipv6_link_local_auto
Each command is listed, in detail, in the following sections: