Filter
Top Products
xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Guide
231
config dst
disable − Disable the DST seasonal time adjustment for the Switch.
repeating − Using repeating mode will enable DST seasonal time
adjustment. Repeating mode requires that the DST beginning and ending
date be specified using a formula. For example, specify to begin DST on
Saturday during the second week of April and end DST on Sunday during
the last week of October.
annual − Using annual mode will enable DST seasonal time adjustment.
Annual mode requires that the DST beginning and ending date be specified
concisely. For example, specify to begin DST on April 3 and end DST on
October 14.
s_week − Configure the week of the month in which DST begins.
<start_week 1-5,last> − The number of the week during the month in which
DST begins where 1 is the first week, 2 is the second week and so on, last
is the last week of the month.
e_week - Configure the week of the month in which DST ends.
Parameters
<end_week 1-5,last> − The number of the week during the month in which
DST ends where 1 is the first week, 2 is the second week and so on, last is
the last week of the month.
s_day – Configure the day of the week in which DST begins.
<start_day sun-sat> − The day of the week in which DST begins expressed
using a three character abbreviation (sun, mon, tue, wed, thu, fri, sat)
e_day − Configure the day of the week in which DST ends.
<end_day sun-sat> − The day of the week in which DST ends expressed
using a three character abbreviation (sun, mon, tue, wed, thu, fri, sat)
s_mth − Configure the month in which DST begins.
<start_mth 1-12> − The month to begin DST expressed as a number.
e_mth − Configure the month in which DST ends.
<end_mth 1-12> − The month to end DST expressed as a number.
s_time – Configure the time of day to begin DST.
<start_time hh:mm> − Time is expressed using a 24-hour clock, in hours
and minutes.
e_time − Configure the time of day to end DST.
<end_time hh:mm> − Time is expressed using a 24-hour clock, in hours and
minutes.
s_date − Configure the specific date (day of the month) to begin DST.
<start_date 1-31> − The start date is expressed numerically.
e_date − Configure the specific date (day of the month) to begin DST.
<end_date 1-31> − The end date is expressed numerically.
offset [30 | 60 | 90 | 120] − Indicates number of minutes to add or to subtract
during the summertime. The possible offset times are 30,60,90,120. The
default value is 60
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To configure daylight savings time on the Switch: