Filter
Top Products
Chapter 8: P2ZCIMs and Z-CIMs
134
7. Press Enter and type RefreshPZ.
8. Press Enter again.
9. Press S to refresh the chain.
10. Press F2 to go to the Selection Menu and verify that channel order of
the chain has been refreshed.
Important: Please follow the guideline here to ensure that there is
enough power to support all P2ZCIMs in a chain.
For Paragon I UMT242, 442, 832 and 1664 with hardware III and
Paragon II firmware, and Paragon II switches, in chains up to 20
individual P2ZCIM units at least one P2ZCIM must be powered ON;
in P2ZCIM chains from 21 to 42 P2ZCIM units, at least 15 P2ZCIMs
must be powered ON.
P2ZCIM LED Status
The LED on each P2ZCIM indicates its operational state:
If the LED blinks rapidly: P2ZCIM does not have a confirmed
Communication Address.
If the LED is primarily off and blinks on every two (2) seconds:
P2ZCIM has a confirmed Communication Address but is not
switched to that Address.
If the LED is on and blinks on/off rapidly when there is
keyboard/mouse traffic: CIM has a confirmed Communication
Address and is switched to that Address.
Note: The P2ZCIM blinks from time to time even if there is no
keyboard/mouse traffic, which demonstrates that the P2ZCIM is
operating normally and not locked.