Filter
Top Products
Chapter 3: Rackmount and Installation
31
a. Press the FUNC button and use the and buttons to select
"Set Stack ID." Press the ENT button to confirm the selection.
b. Assign the Stacking Unit ID using the
and buttons.
7. Press the ENT button to save the setting.
8. Turn OFF all Paragon switches.
9. Turn on the Stacking Unit.
10. Turn on the Main Unit.
Note for Turning Off the Stacking Unit
After completing the hardware installation of the Paragon system,
whenever you want to turn off a Stacking Unit, you must disconnect
it from the Main Unit before turning it off. This is because turning off
the Stacking Unit when it remains connected to the Main Unit results in
incorrect channel color display on the OSUI Selection Menu. If this
occurs, follow this procedure to restore the color display to normal.
To restore the color display to normal
1. Remove the stacking cable connected between Stacking and Main
Units.
2. Turn off the Main Unit.
3. Re-connect the stacking cable between Main and Stacking Units.
4. Turn on the Stacking Unit first.
5. Turn on the Main Unit.
Installation of the HubPac
P2-HubPac is available for use with Paragon II. HubPac devices allow
users of different Paragon switches to access the same server(s). Each
five-port cluster on a HubPac is capable of connecting a server to up to
four Paragon switches.
CIM models capable of connecting to a P2-HubPac include:
P2CIM-APS2
P2CIM-AUSB
P2CIM-ASUN
UKVMC