Filter
Top Products
Chapter 3: Rackmount and Installation
18
Front rackmount of a Paragon switch
Front rackmount of a Paragon user station
Rear Mount
The steps correspond to the numbers shown in the rear rackmount
diagrams.
1. Secure the cable-support bar to the front end of the side brackets,
near the side brackets' “ears,” using two of the included screws.
2. Slide the user station or KVM switch between the side brackets, with
its rear panel facing the cable-support bar, until its front panel is flush
with the back edges of the side brackets.
3. Secure the user station or switch to the side brackets using the
remaining included screws (three on each side).
4. Mount the entire assembly in your rack and secure the side brackets'
ears to the rack's front rails with your own screws, bolts, cage nuts,
and so on.
5. When connecting cables to the rear panel of the user station or
switch, drape them over the cable-support bar.