Filter
Top Products
Chapter 6: Operation - User Functions
78
Press Enter to begin editing; the highlighted area will turn green, and
the message text changes to the following:
See the next section for interpreting specific User Profile entries.
When finished, press Enter to retain the changes (the highlighted
area will turn yellow) or press the Esc key to cancel the changes.
When you are going to leave the menu, (for example, if you press a
function key) the prompt in the message bar will change to “Save the
changes (Y/N/ESC)” Press S to save the changes to long-term
memory, Esc to discard your changes, or N to discard your changes
and exit the menu.
Note: When you type new numeric values, always use the number keys
at the top of your keyboard, not the number keys on your keypad.
Paragon does not support the keypad number keys.
User Profile Parameters and How to Change Settings
Scan Mode: Indicates how Paragon II determines the length of time
to pause at each channel port during autoscanning. Default setting is
“Global.” Use any of the arrow keys to toggle between these values.
Global: the system pauses at each channel port for the same
length of time set in the Global Scan Rate field.
Individual: this indicates that the administrator has set a specific
length of time for each individual channel ports (as displayed in
the Selection Menu).
Global Scan Rate: If Scan Mode is set to “Global,” this parameter
determines the length of time that the system pauses at each
channel port while scanning. Using leading zeroes if necessary, type
in a two-digit number of seconds from 01 to 24, or use the
and
keys to increase and decrease the current value by 1 respectively.
The default setting is 03.
ID Display: The ID Display is a small window that can appear on the
screen to display the name and ID of each channel port as you
switch between them or scan them. Edit the two fields to determine
how the system will show you this window:
Possible values in the first field are “On” (ID Display is shown,
the default value) and “Off” (ID Display isn’t shown). Use any of
the arrow keys to toggle between these values.