Filter
Top Products
Chapter 12: Firmware Upgrade
184
STEP (E): Repeat Steps (B) and (D) for the Other Clusters
After finishing the upgrade of one cluster, continue to upgrade the
remaining clusters.
To upgrade the other clusters, repeat the following procedure
on each cluster
1. Disconnect the Cat5 cable attached with the USB-to-RS485 cable
from the HubPac cluster on which the upgrade has finished.
2. Reconnect the Cat5 cable to the server connection port of “another
cluster” on the same HubPac, as described in STEP (B): Connect
One Cluster of the HubPac to the PC (on page 177).
3. Click Send to
Paragon in the Para
gon Update window to upgrade
the connected cluster. The procedure is the same as those
described in STEP (D): Launch the Paragon Update Utility (on
page 183).
Upon upg
rading 8 clusters successfully, the P2-HubPac firmware update
is complete.