Filter
Top Products
Appendix D: Connecting Serial Devices to Paragon II System
204
Conveniently, you may program any of the PC keyboard's twelve
function keys to trigger your most-often-used data-stream commands.
Pressing any key set this way causes Paragon II to send the
corresponding command to the device. During the online session, you
can also send any of the following key combinations (press and hold Ctrl
or Alt, press and release the command key, and release Ctrl or Alt) to
control your communication with the device or to access AUATC's help
and setup screens:
Ctrl + Break (the Pause/Break key next to the Scroll Lock key):
Resets both AUATC and the serial communication with the device.
Ctrl + S (not case-sensitive): Sends a command to the device to
temporarily stop it from sending any data; until the flow is allowed to
resume, all output data will be queued by the device.
Ctrl + Q (not case-sensitive): Sends a command to allow the device
to resume sending data after being halted by the CTRL + S
command.
Alt + F1: Displays the Help screen.
Alt + F2: Displays the Setup screen.
Alt + F3: Displays the Set Up Programmable Keys screen.
Alt + F4: Switch to Buffer Edit Mode.
Help Mode