Filter
Top Products
132 DSView 3 Software Installer/User Guide
• Deny - the access right is denied for the user/group.
• Inherit - the access right is inherited from the unit group(s) to which the selected user/
group belongs. When Inherit is selected, the Allow and Deny checkboxes will become
gray and unchangeable, and indicate the inherited value. If the inherited settings indicated
both Allow and Deny, the inherited value is Deny, which takes precedence.
To disable the inherit functionality, uncheck the Inherit checkbox.
• If none of the checkboxes are checked, the access right is neither allowed nor denied.
4. Repeat the preceding step to change access rights for other users/user groups.
5. Click Save and then click Close. The Units View window will open.
Managed Appliance Network, Authentication Server and
Version Settings
To change the network settings of a managed appliance:
NOTE: The MAC address cannot be changed.
1. In a Units View window containing appliances (see Accessing Units View windows on
page 98), click on the appliance name.
2. Click Appliance Settings in the side navigation bar and then click Network. The Appliance
Network Settings window will open. To change information:
• Type an IP address, in standard dot notation (xxx.xxx.xxx.xxx).
If you change the appliance IP address in the Appliance Network Settings window, you
must then also change the address in the Unit Network Properties window. See Unit
Properties on page 125. (When changing an IP address, always change it in the Appliance
Network Settings window before changing it in the Unit Network Properties window.)
• Type a subnet, in standard dot notation (xxx.xxx.xxx.xxx).
• Type a gateway, in standard dot notation (xxx.xxx.xxx.xxx).
• Specify a LAN speed. This network setting will not appear for CPS appliances.
• Enable or disable DHCP or BootP (KVM switches).
• Enable or disable ICMP ping reply.
3. Click Save and then click Close. The Units View window will open.
To change the IP addresses of DSView 3 servers used for managed
appliance authentication:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 98), click on the appliance name.
2. Click Appliance Settings in the side navigation bar and then click Authentication Servers. The
Appliance Authentication Servers Settings window will open. To change information, type an