Filter
Top Products
If You Cannot Make Copies As You Want
35
3
If You Cannot Make Copies As You Want
This section explains causes and remedies when copy results are not as expect-
ed.
❖
❖❖
❖ Basic
❖
❖❖
❖ Combine
❖
❖❖
❖ Duplex
Problem Causes Solutions
You cannot combine sever-
al functions.
Selected functions cannot
be used together.
Check the combination of functions
and make the settings again.
Reference
p.53 “Combination Chart”
Problem Causes Solutions
When using Combine,
parts of the image are not
copied.
The copy paper you speci-
fied does not match the siz-
es of your originals.
Make sure the originals can be com-
bined into the copy paper you se-
lected.
Copies are not in correct or-
der.
You placed the originals in
the incorrect order.
When placing a stack of originals in
the ADF, the last page should be on
the bottom.
If you place an original on the expo-
sure glass, start with the first page to
be copied.
Problem Causes Solutions
Order of copies is not cor-
rect.
You set originals in the in-
correct order.
When setting a stack of originals in
the ADF, the last page should be on
the bottom.
If you set an original on the expo-
sure glass, start with the first page
to be copied.
In Duplex Margin mode,
parts of the original image
are not copied.
The margin is too wide. Set a narrower margin with User
Tools. You can set the width be-
tween 0–50 mm (0"–2"). See p.45
“Duplex Margin”.
There is a lack of margin
space on the opposite side
of the binding position.
When using Duplex, copy
is made Top to Top even
though Top to Bottom is se-
lected.
You placed the originals in
the wrong orientation.
Place the originals in the correct ori-
entation. See p.15 “Original Orien-
tation” .
StellaC2_GBcopy_F1_pre_FM.book Page 35 Tuesday, December 16, 2003 4:39 PM