Filter
Top Products
Connecting the Network Cable to the Network
10
2
Connecting to the Ethernet
Interface
The network interface board supports
10BASE-T or 100BASE-TX connec-
tions.
A
AA
A
Turn off the main power switch.
Important
❒ Make sure the main power is
off. See “Turning On the Pow-
er”, Copy Reference.
B
BB
B
Loop the network interface cable
and attach the ferrite core.
Note
❒ The network interface cable
loop should be about 15 cm
(6”)(A) from the end of the ca-
ble (closest end to the printer).
The ferrite core at the end of the
cable should be a ring type.
C
CC
C
Connect the Ethernet interface ca-
ble to the 10BASE-T/100BASE-TX
port.
D
DD
D
Turn on the main power switch.
1. Indicator (green)
Remains green when the machine is
properly connected to the network.
2. Indicator (yellow)
Turns yellow when 100 BASE-TX is
operating. Turns off when 10 BASE-T
is operating.
AAW026S1
ABW023S1
AAW022S1
1.
2.