Filter
Top Products
Preparing to Print
34
2
• Windows Me
A In the [Add New Hardware Wiz-
ard] dialog box, confirm that
[Windows has found the follow-
ing new Hardware: IEEE SBP-2
Device] is displayed, and click
[
Recommended search for a bet-
ter driver [Recommended]], and
then click [
Next
].
B When “Windows was unable
to locate the software for this
device.” appears, click [Fin-
ish].
❖
❖❖
❖ If you do not want to install the printer
when [Found New Hardware Wizard]
starts when using an operating sys-
tem that supports SCSI print, disable
the device with the following proce-
dure:
• Windows 2000
A In the [Found New Hardware
Wizard] dialog box, click
[Next].
B When “This wizard will com-
plete the installation for this
Device: Unknown” appears,
click [
Search for a suitable driv-
er for my device [recommend-
ed]], and then click [Next].
C
When “Locate Driver Files”
appears, remove all selec-
tions from [
Optional search lo-
cations.
], and then click [
Next
].
D When “Driver Files Search
Results” appears, click [Disa-
ble the device. The Add/Remove
Hardware Wizard in the control
panel can be used to complete
the driver installations.
], and
then click [
Finish
].
•
Windows XP and Windows Serv-
er 2003
A
In the
[Found New Hardware Wiz-
ard]
dialog box,
confirm “This
wizard helps you install soft-
ware for: Unknown” is dis-
played, and click [
Install from
a list or specific location (Ad-
vanced)
], and then click [
Next
].
B When “Please choose your
search and installation op-
tion.” appears, remove all se-
lections from [Search for the
best driver in these locations.],
and then click [Next].
C When “The wizard could not
find the software on your
computer for..” appears,
click [OK].
D When “Cannot Install this
Hardware” appears, select
the [Don't prompt again to install
the software] check box, and
then click [Finish].
❖
❖❖
❖ If
[
Found New Hardware Wizard
]
ap-
pears every time you restart the com-
puter when using an operating
system that does not support IP over
1394, or plug in/take out the cable,
disable the device with the following
procedure:
• Windows 2000
A In [Found New Hardware Wiz-
ard] dialog box, click [Next].
B When “This wizard will com-
plete the installation for this
Device:” and “IP over 1394”
appear, click [
Search for a suit-
able driver for my device [recom-
mended]], and then click
[
Next
].
C
When “Locate Driver Files”
appears, remove all selec-
tions from [Optional search lo-
cations.], and then click [Next].
StellaC2-GB-Pref1-F3_FM_ZF.book Page 34 Friday, November 21, 2003 8:42 PM