Filter
Top Products
Faxing
26
2
Dialing
There are four main ways to dial a
number:
❖
❖❖
❖ Entering Numbers Directly
See p.26 “Entering Numbers Di-
rectly”
❖
❖❖
❖ Using Quick Dials:
See p.27 “Using Quick Dials”
❖
❖❖
❖ Using Speed Dials:
See p.28 “Using Speed Dials”
❖
❖❖
❖ Using Groups
See p.29 “Using Groups”
Entering Numbers Directly
Enter numbers directly using the
number keys on the right side of the
operation panel.
Note
❒ Maximum length of a fax number:
254 digits.
❒ You can insert pauses and tones in
a fax number. See p.27 “Pause”,
p.27 “Tone”
A
AA
A
Make sure that the machine is in
standby mode.
B
BB
B
Set your original and select any
scan settings you require.
C
CC
C
Enter the fax number with the
number keys.
The digits appear on the display as
you enter them.
Note
❒ If you make a mistake, press the
{
{{
{Clear/Stop}
}}
} key and enter
again.
❒ If you wish to send this message
to more than one destination,
press the {
{{
{OK}
}}
} key, and then en-
ter the next destination.
D
DD
D
Press the {
{{
{Start}
}}
} key.
-
--
- Limitations when dialing with
the number keys
Fax numbers entered with the num-
ber keys are stored in internal memo-
ry (separate from memory for storing
original data). Therefore, using the
number keys, you cannot program
more than 67 numbers for the follow-
ing:
• Destinations specified in a Memo-
ry Transmission (including Polling
Reception)
• Destinations specified in a Group
For example, when 60 destinations
are registered in a Group with the
number keys, only 7 destinations can
be dialed for Memory Transmission
from the number keys.
StellaCEN-basic_V4_FM.book Page 26 Thursday, July 19, 2001 1:39 PM