Filter
Top Products
Error & Status Messages on the Display
13
2
Ethernet Board Error An error has occurred in the
Ethernet interface.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Exceeded max. print size.
Press FormFeed/JobReset
The page images to be printed
exceed the maximum print ar-
ea.
Press [JobReset] to change the
paper tray settings, or press
[FormFeed] to print regardless.
I/O buffer overflow. The maximum size of the I/O
buffer has been exceeded.
Increase the size of the I/O
buffer through the Host Inter-
face menu.
Load paper in Tray # There is no paper in the select-
ed paper tray.
# indicates the tray number.
Load the tray with paper.
NV-RAM Error An error has occurred in the
printer.
Turn off the main power
switch, and back on again. If
the message appears again,
call your sales or service repre-
sentative.
Paper in Duplex Unit. Open
cover and remove the paper.
There is a misfeed in the du-
plex unit.
Open the cover of the duplex
unit, and remove the misfed
paper.
Paper size/type mismatch.
Change settings to:
xxx yyy
There is no paper tray that
matches the paper settings se-
lected under Auto Tray Select.
xxx indicates the tray number.
yyy indicates the paper size
and the paper type.
Press [JobReset] to change the
paper tray settings, or press
[FormFeed] to print regardless.
For details about the paper
tray settings, see General Set-
tings Guide.
Parallel I/F Error An error has occurred in the
parallel interface board.
Contact your sales or service
representative.
Printer Font Error An error has occurred in the
font file.
Turn off the main power
switch, and back on again. If
the message appears again,
call your sales or service repre-
sentative.
Print overrun. The image data has been
thinned out due to image com-
pression.
Increase memory capacity.
When installing a memory
module in the machine, con-
tact your sales or service rep-
resentative.
Problem:IEEE1394 board An error may have occurred in
the IEEE 1394 board.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Problem:IEEE802.11b card An error may have occurred in
the IEEE 802.11b card.
Problem:IEEE802.11b board An error may have occurred in
the IEEE 802.11b board.
Messages/Second messages Causes Solutions