Filter
Top Products
Remote Maintenance by telnet
91
9
SMB
Use the “smb” command to configure
or delete the NetBEUI settings such as
the computer name or workgroup
name.
msh> smb parameter
Note
❒ You cannot use a computer name
starting with “RNP” or “rnp”.
ROUTE
Use the “route” command to control
the routing table.
This command allows you to config-
ure and display routing information.
You can change the network configu-
ration from remote computers using
this command.
Note
❒ The maximum number of routing
tables is 16.
*1
IP address
SLP
Use the “slp” command to configure
SLP settings.
You can search the NetWare server
using SLP in the PureIP environment
of NetWare5/5.1, 6. Use the “slp”
command to configure the value of
TTL used by the SLP multi-cast-pack-
et.
Note
❒ The default value of TTL is “1”. A
search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
Parameter Settings
comp Your computer name consist-
ing of up to 15 characters
group Workgroup name consisting
of up to 15 characters
comment Comment consisting of up to
31 characters
notif {on |
off}
You can enable or disable no-
tification of print job comple-
tion.
clear comp Clears the computer name
clear group Clears the Workgroup name
clear com-
ment
Clears comment
Commands Topics of setting
route add
{host | net}
destination
*1
gateway
*1
Adds a host/network route
to “destination”, and a gate-
way address to “gateway” in
the table. Host becomes the
default.
route de-
lete {host |
net} desti-
nation
*1
Deletes a host/network route
from the table. Host becomes
the default.
route get
{destina-
tion
*1
}
Displays only route informa-
tion corresponding to a spec-
ified destination. When the
destination is unspecified, all
routing information is dis-
played.
route active
{host | net}
destination
*1
on/off
You can turn the specified
destination on or off. Host be-
comes the default.
route add
default
gateway
*1
You can set the default gate-
way address.
route flush Deletes all routing informa-
tion.
Commands Topics of setting