Filter
Top Products
Section 9 TROUBLESHOOTING
9-2
“Exceeds pre registered copying quantity.”
[“Copy limit for this ID-code has been reached.
No copying possible.”]
The number of copies made under your department code has reached the
limit that was set under the copy management mode and copying is no
longer possible with that code. Use the copy management mode to clear the
copy count.
7-1
“Unable to copy.(Full-color) Exceeded the
limitation of management”
[“You cannot copy.(Full Colour) Exceeded the
limitation of management”]
Full color copying is not available as you have reached the limit that was
set under the copy management function for that type of copying. To
continue making full color copies, use the copy management function to
clear the corresponding copy count.
7-1
“Unable to copy.(Full-color) ID-code capacity
has limit.”
[“You cannot copy.(Full Colour) ID-code capacity
has limit.”]
Full color copying is not available because it has been restricted. To make
full color copies, use the copy management function to change the
corresponding restriction.
7-1
“Paper capacity is over limited unable to copy.
Change preset of color or B&W selection.”
[“Limit of set was exceeded, can not copy.
Change preset of colour or B&W selection.”]
You are attempting use the Color/BW selection mode to make a number of
copies that will exceed the designated copy limit. Change the total number
of copies to be made (both color AND black and white) to a lesser number
that will not exceed that copy limit.
---
“The ID-Code is checked. Remote edit.”
[“The ID-Code is checked. Remote editing.”]
A computer on your network is currently performing one of the “Editing
copy management information” procedures. Copying will not be possible
until that operation is completed.
---
“Set toner container.” One or more of the toner containers is not set at all or is not set properly.
Set the toner containers properly. There is insufficient toner left in the
indicated toner container.
10-4
“Ready to copy. Toner will be empty
soon.(K,C,M,Y)”
You will soon need to replace the indicated toner container (C = cyan, M =
magenta, Y = yellow and K = black). Make sure you have the appropriate
replacement toner container ready.
10-4
“Add toner.(K,C,M,Y)” The copier has run out of toner of the color indicated. Replace the
corresponding toner cartridge immediately (C = cyan, M = magenta, Y =
yellow and K = black).
10-4
“Check waste toner box.” • The waste toner box is full of toner. Replace the waste toner box
immediately.
• The waste toner box is not set properly. Set the waste toner box properly.
10-6
“Call service.” Open and then close the front cover. If this message still remains, make a
note of the number that is displayed together with the letter “C”. Then,
turn the power switch OFF ({), and contact your service representative or
authorized service center.
---
“System error. Main switch off / on.”
[“System error. Main switch Off / On.”]
An error has occurred. Turn the power switch OFF ({) and then back ON
( | ) again.
---
“System error. Disconnect power plug from the
socket.”
An error has occurred. Remove the power plug from the wall outlet. ---
“Time for maintenance.(ABC)” Periodic maintenance is required to keep your copier in good condition.
Contact your service representative or authorized service center
immediately.
The type of maintenance kit required (from A to C) will be displayed in the
message area of the touch panel.
---
“Memory full.” Operation has been stopped because the copier’s memory is full. Press the
“OK” key.
If the error occurred during scanning of originals, press either the
“Continue” key or the “Cancel” key, as appropriate.
“Continue”: Copies will be made for those originals that have already been
scanned.
“Cancel”: Delete all of the scanned data.
---
Message Procedure
Reference
page