Filter
Top Products
Section 9 TROUBLESHOOTING
9-5
If a paper misfeed occurs, a message will be displayed in the touch
panel about the misfeed and copying will stop. Leave the power
switch ON ( | ) and refer to “Removal procedures” on page 9-6 to
remove the jammed paper.
Inch specifications
Metric specifications
Cautions
* Do not reuse misfed paper.
* If paper is torn during removal, be sure to remove any loose
scraps of paper from inside the copier. Loose scraps inside the
copier could cause another misfeed later.
* Once misfed paper has been removed, warm-up will begin. The
misfeed indications will disappear, and the copier will return to
the same settings prior to the misfeed.
* If a misfeed occurs in the optional Document Finisher, do not add
the misfed copy to the other copies in the Document Finisher
tray, as that copy will be automatically made again.
* When a misfeed occurs, if the power switch is turned OFF (O)
without removing the jammed paper, a message about the
misfeed and “J00” will be displayed the next time the power
switch is turned ON ( | ) again.
In such a case, follow the procedure displayed on the touch panel
to remove the jammed paper.
Misfeed location indicators
(1) Misfeed in the paper feed section (Page 9-6.)
(2) Misfeed in the paper conveyor unit (Page 9-9.)
(3) Misfeed in the transfer unit (Page 9-10.)
(4) Misfeed in the fixing section (Page 9-12.)
(5) Misfeed inside the left cover or near the copy storage
table (Page 9-14.)
(6) Misfeed in the Duplex Unit (Page 9-15.)
(7) Misfeed in the optional Document Processor
(Page 9-16.)
(8) Misfeed in the optional Document Finisher (Page 9-17.)
If paper jams
WARNING
High voltage is present in the charger section.
Take sufficient care when working in this area, as
there is a danger of electrical shock.
CAUTION
The copier’s fixing unit is extremely hot. Take
sufficient care when working in this area, as there
is a danger of getting burned.
(1)
(2) – (5)
(6)
(8)
(7)