Filter
Top Products
Section 6 OTHER CONVENIENT FUNCTIONS
6-5
Interrupt copying is useful if, during one copy job, you want to copy
other originals at different settings. Once the rush job is completed,
the interrupted copy job can be resumed at the same settings as
before.
1
Press the [Interrupt] key to light the lamp in the
[Interrupt] key.
“Interrupt mode OK” will be displayed.
2
Remove the originals that were currently being copied and
put them aside.
3
Set the new originals and perform the desired copy
procedure.
4
When copying is completed, press the [Interrupt] key once
again, and replace the newly copied originals with the ones
removed before.
Then, press the [Start] key. The interrupted copy job will be
resumed.
NOTE
Copy will be resumed using the data that was scanned
into the hard disk. There is no need to rescan the same
original data.
Interrupt copying