Filter
Top Products
Section 9 TROUBLESHOOTING
9-17
3
Open the left cover to the Document Processor.
NOTE
Be sure to hold the handle in the middle of the cover when
opening it.
4
If there are any originals there, remove the jammed
original without tearing it.
NOTE
If the original does happen to tear, remove any loose
scraps from inside the Document Processor.
5
Open the paper conveyor cover (shown as (1) in the
illustration).
6
If there are any originals there, remove the jammed
original without tearing it.
NOTES
• If the original does happen to tear, remove any loose
scraps from inside the Document Processor.
• If the original is difficult to remove at all, turn the
green original feed dial (shown as (2) in the
illustration). The misfed original will be fed out to a
location that makes it easier to remove.
7
Close the paper conveyor cover.
8
Close the left cover. The original set indicator should go
out. Reset the originals and start copying again.
NOTE
Be sure to hold the handle in the middle of the cover when
closing it.
Misfeed in the optional Document Finisher
If a misfeed occurs in the Document Finisher, refer to the
Operation Guide for the Document Finisher and remove the
jammed paper.
(1)
(2)