Q-Logic FC HBA CLI Network Card User Manual


 
4 – Interactive Commands
Diagnostics Menu (Command Line Options -kl, -kr, and -dm)
4-64 SN0054614-00 F
S
Loopback Test
Read/Write Buffer Test
Transceiver Details (available on 4Gb and 8Gb only)
Test results for loopback and read/write buffer tests may include these test results:
Loopback test results:
Test Status
CRC Error
Disparity Error
Frame Length Error
Read/Write buffer test results:
Loop ID/Status
Data Miscompare
Link Failure
Loss of Sync
Loss of Signal
Invalid CRC
4.12.1.1
Configure Loopback Test Parameters
12: Diagnostics n: Port Number 1: Loopback Test
When you select the Loopback Test option, SANsurfer FC HBA CLI shows the
Loopback Test Menu containing the following options:
Display Test Parameters
Reset Test Parameters
Configure Test Parameters
Start Diagnostics Test
Diagnostic tests interrupt normal HBA operations. At the completion of the testing,
the HBA’s state before the tests are restored. Note the following:
Run these tests when no other activities are required of the HBA.
Tests read and write to sensitive areas on the HBA.
Disruption of some diagnostic tests may require a complete update of the
HBA's critical memory areas.
NOTE:
Although SANsurfer FC CLI protects against normal operation interruption
and testing disruption, it is your responsibility to ensure that the diagnostics
are run without causing interruptions to other processes and disruptions to
the actual testing process.