Filter
Top Products
5 – Non-interactive Commands
Command Summary
5-6 SN0054614-00 F
S
You can use either the hyphen (-) character or the forward slash (/)
character. For example, both of these commands are valid:
scli -g
scli /g
Table 5-2 defines the command variables.
.
5.3.1
-a
(View or Toggle Beacon Status)
Use the -a command to either view (1) or change (2) the status of a beacon.
Table 5-2. Command Variables
Variable Definition Format
<HBA Instance> or
<Instance number>
HBA number
a
a
You can use the -g command to find HBA numbers.
<HBA WWPN> HBA world wide port name xx-xx-xx-xx-xx-xx-xx-xx or
xxxxxxxxxxxxxx
<Alias> HBA Alias
Symbolic HBA
b
name
b
You assign the symbolic name. It is limited to 100 characters in length.
<Target WWNN> Target world wide node
name
xx-xx-xx-xx-xx-xx-xx-xx or
xxxxxxxxxxxxxx
<Target WWPN> Target world wide port
name
xx-xx-xx-xx-xx-xx-xx-xx or
xxxxxxxxxxxxxx
<Target Port ID> Target port ID xx-xx-xx or xxxxxx
<Target ID> Target ID
<LUN ID> Logical unit number (0–255)
<Address> IP Address xxx.xxx.xxx.xxx
(speed) Target link speed 1.2 or 4 GHz
NOTES:
HBA must not be in silent mode. See section 5.3.28 to issue a response
to this command.
The -a feature is not supported on QLA22xx HBAs.