Filter
Top Products
5 – Non-interactive Commands
Command Summary
SN0054614-00 F 5-5
A
5.3
Command Summary
The command format for non-interactive mode is:
# scli -(Cmd) (<HBA Instance> | <HBA WWPN>) (view | ?)
Where:
You can combine the commands -o, -s and -x with other options. However, they
must be at the beginning or at the end of the command line. Use these commands
as follows:
-o = Output the results to a file (see section 5.3.23). For example:
# scli -l -o
-s = Silent mode (see section 5.3.28). For example:
# scli -i all -s -o output.txt
-x = Outputs the results in XML format (see 5.3.34). For example:
# scli -i all -x -o output.xml
You cannot combine the command -f with any other options:
-f = Input Parameter Options from a Text File (see section 5.3.8). For
example:
# scli -f command.txt
In addition, the following general rules for commands apply:
Only one command line option per input file is valid.
-i
Show
HBA information (VPD information for QLA/QLE24xx
only)
5.3.15
-l Show LUN list 5.3.19
-m Configure selective LUNs 5.3.21
-p Configure target persistent binding 5.3.24
-t Show target list 5.3.29
HBA Instance = HBA port instance (use -g command to find)
HBA WWPN = HBA World wide port name
Table 5-1. Options Shown by -z (Continued)
CLI Description See Section