Q-Logic FC HBA CLI Network Card User Manual


 
Page vi SN0054614-00 F
S
SANsurfer FC HBA CLI User’s Guide
Command Line Interface for QLogic Fibre Channel Host Bus Adapters
Configure HBA Settings (-n): added option to
restore the BIOS (QLA/QLE/QEM24xx HBAs).
4.7.1, Section 5.3.22
Selective LUNs (command line option -m): added
ALL option to command line to view all selective
LUNs for all HBA ports.
4.8.1.2, Section 5.3.21
Set Boot Device (-e): removed references to OSs
from the third paragraph; this command now
applies to all OSs.
4.9.2.1.1
Diagnostics (command line options -kl and -dr):
DataPattern (DP) parameter: added CRPAT,
CSPAT, and CJTPAT.
DataSize (DS) parameter: added 128-byte value
for read/write buffer test. Added 128, 256, 512,
1024, 2048, 4096, 8192, 16384, 32768, 65535
byte values for loopback test. Added default val-
ues.
TestCount (TC) parameter: changed the number of
loopback tests that can be run from 0–10000 to
0–65535.
TestIncrement (TI) parameter: increased test incre-
ment for the loopback test from 1–10000 to
1–65535.
4.17.1.2.1, 5.3.17
4.17.1.2.2, Table 5-5
4.17.1.2.3, Table 5-5
4.17.1.2.4, Table 5-5
Output in XML Format (command line option -x):
Added XML format for HBA alias (command line
option -ha).
Added XML format for HBA port alias (command
line option -pa).
Added XML format for SFF DMI (command line
option -dm).
Added XML format for host topology (command
line option -tp).
Section 5.3.34
Section 5.3.14
Section 5.3.25
Section 5.3.5
Section 5.3.31
Target Persistent Binding (command line option
-p): added ALL parameter to show target persistent
binding information for all HBA ports.
Section 5.3.24