Q-Logic FC HBA CLI Network Card User Manual


 
4 – Interactive Commands
Target Link Speed or iiDMA Settings Menu (Command Line Option -q)
SN0054614-00 F 4-39
A
8. All HBAs
9. Return to Previous Menu
Table 4-3 lists the target link speed settings and descriptions.
4.5.1
Configuring the iiDMA Settings
Use the Intelligent Interleave Factor Selection (iiDMA) menu to select the
intelligent interleave factor settings per HBA type and device.
To configure iiDMA settings:
1. From the SANsurfer FC HBA CLI main menu, select iiDMA Settings.
2. Select the HBA that you want to apply the Intelligent Interleave factor
update.
3. Select one of the following options:
Basic Configuration if you want to apply the Intelligent Interleave
factor update to all devices attached to this adapter.
Advanced Configuration if you want to select an apply different
Intelligent Interleave factor update to each device attached to this
adapter.
Table 4-3. Target Link Speed Settings
Target Link Speed Settings Description
<address> IP Address.
<hba instance> HBA number (HBA instance number).
<hba wwnn> HBA World Wide Port Name, format
xx-xx-xx-xx-xx-xx-xx-xx or xxxxxxxx.
<lun id> Logical Unit Number (0–255),
<speed> Target Link Speed (iiDMA) - (1, 2, or 4 Gbs).
<target id> Target ID.
<target portid> Target World Wide Port Name, format xx-xx-xx
or xxxxxx.
<target wwnn> Target World Wide Node Name, format
xx-xx-xx-xx-xx-xx-xx-xx or xxxxxxxx.
<target wwpn> Target World Wide Port Name, format
xx-xx-xx-xx-xx-xx-xx-xx or xxxxxxxx.
-targets | -t All targets.