Filter
Top Products
Page iv SN0054614-00 F
S
SANsurfer FC HBA CLI User’s Guide
Command Line Interface for QLogic Fibre Channel Host Bus Adapters
Changed bullets describing interactive and
non-interactive modes.
Section 2.2, Section 2.3
Clarified the note about starting SANsurfer FC
HBA CLI on a Solaris console serial port.
Section 2.2
Added Macintosh column to Table 2-1. Section 2.3
Added support for Linux IOCTL module driver and
driver on the OS installation CD (inbox driver).
Section 3, Section 4, Section 5
Split Windows command line installation into two
sections (standard and silent). Changed installa-
tion instructions. Added new parameters to com-
mand line for silent installation.
Section 3.2.1.2
Split Solaris installation and uninstallation into
three sections:
Solaris SPARC 6 and 7
Solaris SPARC 8, 9, 10
Solaris x86 8, 9, 10
(These Solaris versions no longer supported.)
Section 3.2.3.1, Section 3.3.3.1
Section 3.2.3.2, Section 3.3.3.2
Added Mac OS X command line installation
instructions.
Section 3.2.4.2
In Windows uninstall (standard), added how to
invoke the exe package and remove the installed
features.
Section 3.3.1.1
In Windows uninstall (command line), changed the
uninstall directions.
Section 3.3.1.2
Added Mac OS X instructions to manually uninstall
the package.
Section 3.3.4
Replaced node name, port name, WWPN, and
WWNN with variables (xx) in screen shots for
security purposes.
Section 4
Added a note to Display LUN List and Selective
LUNs sections defining the maximum number of
LUNs supported by the Solaris QLA and QLC driv-
ers.
Section 4.7
Added text to the Target Persistent Binding section
defining the number of targets and the range of tar-
get IDs for Solaris, which is based in the HBA type.
Section 4.6, Section 4.6.2
Changed Boot Device Selection to Boot Device
Settings.
Section 4.8