Q-Logic FC HBA CLI Network Card User Manual


 
4 – Interactive Commands
Virtual Menu (Command Line Option -vp)
SN0054614-00 F 4-83
A
The Show Link Status option shows a menu of port numbers from which you can
select the port for which you want the link status.
To view the link status:
1. Type the number for the Statistics option, and then press ENTER.
2. The Statistics Menu appears. Type the number for the Link Status option,
and then press ENTER.
3. The Link Status Menu appears. Type the number for the Show Link Status
option, and then press ENTER.
4. You are prompted to select an HBA port. Type the number for the port, and
then press ENTER. The HBA link status for that port appears.
--------------------------------------
Link Status
--------------------------------------
The following keys are in use during test:
<R> | <r> - Reset Current
<C> | <c> - Refresh Current
<T> | <t> - Refresh Total
<RETURN> - Abort Test
---------------------------------------------------------------
Port Name Link Failure Sync Loss Signal Loss Invalid CRC
---------------------------------------------------------------
Port(WWPN)0 0 0 0
Disk(WWPN) 0000
Disk(WWPN)0 0 0 0
Disk(WWPN) 0000
Disk(WWPN)0 0 0 0
Disk(WWPN)0 0 0 0
Press <Enter> to continue:
4.14
Virtual Menu
(Command Line Option -vp)
14: Virtual Menu
NOTE:
The option to use N_Port ID Virtualization (NPIV) only appears on the Main
Menu if the HBAs and system support it. NPIV requires a Windows system
running with a driver that supports NPIV.