Q-Logic FC HBA CLI Network Card User Manual


 
5 – Non-interactive Commands
Command Summary
5-34 SN0054614-00 F
S
5.3.24
-p
(Display Persistent Target Binding Info)
With this command you can:
Show binding information for one or on all HBAs (1)
Bind a specific target to a selected HBA (2)
Bind all targets on a specific HBA or on all HBAs (3)
Unbind a specific target (4)
Unbind all targets on a specific HBA or on all HBAs (5)
To show target persistent binding information for a specific HBA port, type:
# scli -p (<HBA Instance> | <HBA WWPN>) (view | ?)
To show persistent binding information for all HBAs, type:
# scli -p all (view | ?)
Where:
The following example is a typical SANsurfer FC HBA CLI screen showing all
targets currently bound to an HBA:
--------------------------------------------------------------------------
HBA 0: QLA2462 Port 1 WWPN xx-xx-xx-xx-xx-xx-xx-xx Port ID 11-06-EF
--------------------------------------------------------------------------
Bind Type Device Node Name Device Port Name Port ID ID
---- ---- ---------------- ---------------- ------- --
No Disk xx-xx-xx-xx-xx-xx-xx-xx xx-xx-xx-xx-xx-xx-xx-xx 10-02-E1
Yes Disk xx-xx-xx-xx-xx-xx-xx-xx xx-xx-xx-xx-xx-xx-xx-xx 10-02-E2 0
NOTES:
Under Solaris, if you use the driver from the OS installation CDs (QLC
driver), these features are disabled.
Under Linux, if you use the ioctl or sysfs (inbox) driver these features are
disabled.
HBA Instance = HBA number (use -g command to find)
HBA WWPN = World wide port name of the HBA
NOTE:
In Solaris SPARC using a csh or tsch shell, include double quotes around
the question mark (?). For example:
# scli -p <HBA>"?"