Filter
Top Products
1 – Introduction
System Requirements
1-6 PRELIMINARY SN0054614-00 F
S
256 MB physical RAM are required to run SANsurfer FC HBA CLI; running
with less memory can cause disk swapping (“paging” or “paging out”), which
severely affects performance.
Video card capable of 256 colors and a screen resolution of 800x600 pixels.
About 7 MB of disk space.
1.5.2
Software Requirements
The minimum software requirements are as follows:
QLogic drivers for your OS platform.
Administrative privileges to do management functions.
One of the operating systems listed in section 1.4.
1.5.2.1
Unsupported Features
Depending on your system, not all SANsurfer FC HBA features are available.
1.5.2.1.1
Features Not Available When Running Windows Driver with NPIV
Enabled
When running the driver with NPIV enabled on Windows, the following features
are not available with virtual port:
HBA parameters settings
HBA parameters restore default
Flash update from file
Flash save to file
HBA parameters update from file
HBA parameters save to file
HBA parameters update from templates
Target link speed
Boot device settings
Driver settings
HBA beacon
Target/LUN list
NOTE:
Tape devices are shown as part of the configuration, but are not fully
supported by SANsurfer FC HBA CLI. Only persistent binding and LUN
masking are available.