Q-Logic FC HBA CLI Network Card User Manual


 
SN0054614-00 F 4-1
Section 4
Interactive Commands
This section describes the interactive mode command line options for specific
QLogic FC HBAs. The interactive mode uses a series of menus from which you
select the option you want and enter the number for that option. (See Section 5 for
non-interactive mode operation in which you simply enter a one- or two-letter code
to perform operations on the HBA.)
To start the interactive mode, type one of the following:
[ scli ]
[ scli int]
(on some Solaris installations)
When you start SANsurfer FC HBA CLI in interactive mode, the Main Menu
appears as follows:
Main Menu
1: General Information
2: HBA Information
3: HBA Parameters
4: Target/LUN List
5: Target Link Speed
or 5: iiDMA Settings
6: Target Persistent Bindings
7: Selective LUNs
8: Boot Device
9: Driver Settings
10: Utilities
11: Beacon
12: Diagnostics
13: Statistics
14: Help
or 14: Virtual (if available)
15: Exit or 15: Help
or 16: Exit
NOTE:
Selections on the Main Menu may differ, depending on your system:
Selection 5: may be either Target Link Speed or iiDMA Settings.
The Virtual menu selection is available only on Windows systems
running with a driver that supports NPIV (N_Port ID Virtualization).