4 – Interactive Commands
HBA Parameters Menu
4-26 SN0054614-00 F
S
Frame Size: 512
Frame Size: 1024
Frame Size: 2048
Type the number for the frame size you want and press ENTER.
4.3.1.2.4
Hard Loop ID
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Hard Loop ID
This option prompts you to enter a valid Hard Loop ID from 0 to 125. Type the
number you want and press ENTER.
4.3.1.2.5
Loop Reset Delay
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Loop Reset Delay
This option prompts you to enter a Reset Delay from 0 to 255 seconds. Type the
number you want for the loop reset delay and press ENTER.
4.3.1.2.6
Enable HBA Port BIOS
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Enable HBA Port BIOS
This option allows you to enable or disable the BIOS boot setting. When this
setting is disabled, the ROM BIOS on the HBA is disabled. If you are booting from
a FC hard disk attached to the HBA, you must enable this setting. The default is
disabled.
4.3.1.2.7
Enable HBA Hard Loop ID
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Enable HBA Hard Loop ID
This choice gives you the option to enable or disable the Hard Loop ID. Type the
number you want and press ENTER.
4.3.1.2.8
Enable Fibre Channel Tape Support
3: HBA Parameters N: Port Number 2: Configure HBA Parameters n. Enable Fibre Channel Tape Support
This choice gives you the option to enable or disable Fibre-Channel Tape support.
Type the number you want and press ENTER.