Q-Logic FC HBA CLI Network Card User Manual


 
5 – Non-interactive Commands
Command Summary
5-40 SN0054614-00 F
S
5.3.31
-tp
(Display Host Topology)
Use the -tp option to show the topology configuration of the host:
# scli -tp | topology
Under Linux, this feature is disabled if you are using the ioctl or sysfs (inbox)
driver.
Section 5.2.3 covers this command.
5.3.32
-v
(Display Version)
To show the version number of the SANsurfer FC HBA CLI tool, type:
# scli -v
The system shows the following information:
SANsurfer FC HBA CLI
v1.x.x Build x
Copyright 2003-2007 QLogic Corp.
All rights reserved.
Command Line QLogic FC Host Bus Adapters.
Build Type: Release
Build Date: xx/xx/xxxx xx:xx:xx AM
5.3.33
-vp
(Virtual Port)
To list all virtual ports on a physical HBA port, type:
# scli -vp (<HBA Instance> : <HBA WWPN>) list all
NOTES:
The <0 | ON> option flashes the LED until interrupted. The <1 |
PRESET> option flashes the LED 12 times.
This feature is supported only on JBOD devices.
NOTE:
This option is valid only in non-interactive mode.