5 – Non-interactive Commands
Display System Information (Command Line Options -g, -z, and -tp)
5-4 SN0054614-00 F
S
Port State
Port Information
Physical Port Number (switch port number), including:
Port state
Port type
TX port type
Port module type
Attached Port (QLogic HBA, tape device, or disk device connected to
the switch physical port), including:
Target/initiator
Node name
Port name
Vendor ID
Product ID (if applicable)
Product revision (if applicable)
Product serial number (if applicable)
HBA model (if applicable)
HBA serial number (if applicable)
HBA alias (if applicable)
Port alias (if applicable)
Driver version
Firmware version
Total number of devices (if applicable)
Host (if applicable)
5.2.4
Host Configuration
Use these options to show the information for one or all of the HBA ports in the
system. The -z option shows the combination of the commands listed in
Table 5-1. The commands are listed in alphabetical order.
.
Table 5-1. Options Shown by -z
CLI Description See Section
-c
Show
HBA settings
5.3.3
-e Configure boot device 5.3.6
-fg View driver settings 5.3.9
-g Show system information 5.3.11