Filter
Top Products
Error & Status Messages on the Operation Panel
45
6
Note
❒ If you cannot solve the problem by taking above actions, turn the printer
power off and then back on again. If this does not clear the error message,
write down the error message, and contact your sales or service representa-
tive.
Getting Printer Information over the Network
Printer Current Status
You can check the printer's current status using the "mshel".
❖
mshell
Use status command.
Reference
For more information, refer to the Operating Instructions of the optional
network interface board.
Reset PCU The photoconductor unit is
not installed in the printer.
Call your sales or service
representative.
Reset Fusing
Unit Correctly
The fusing unit is not set cor-
rectly.
Set the fusing unit correctly.
Resetting Job... Job is being reset. Wait for a while.
Reset Tray 1
Correctly
Tray 1 is not set correctly. Set tray 1 correctly.
Reset Tray 2
Correctly
Tray 2 is not set correctly. Set tray 2 correctly.
Warming Up... The printer is now preparing
for printing.
Wait until the printer is
warmed up.
Waiting... Printer is waiting for the next
data to print.
Wait for a while.
Messages Description Resolution
Add Toner The printer is out of toner. Prepare a new toner car-
tridge.
Call Service SC_XXX The Service Code or SC num-
ber identifies the failure.
Call your sales or service
representative.
Call Service Power Off
On
Communicate error from en-
gine to controller.
Turn the machine off and
then on again to restart.
Messages Description Resolution