Filter
Top Products
IMMEDIATE TRANSMISSION
31
2
E Press the {
{{
{
Start
}
}}
} key.
The machine calls the destination.
While it is dialing, the number or
name which is programmed as the
RTI or CSI in the machine of the
other party is shown on the dis-
play. When connected, the ma-
chine starts scanning the original.
Reference
P.156 “RTI/TTI”
After transmission the machine
will return to standby mode.
-
--
-
If the Connection Could Not Be
Made
If it was not possible to make a con-
nection with the number you dialed
(e.g., the line was busy or there is a
line problem), the following display
will appear.
You have two options:
• To have the machine redial and try
and send the message by Memory
Transmission, press
[
Memory TX
]
.
All originals will be scanned into
memory then redialing will begin.
• To cancel this transmission, press
[
Cancel
]
then
[
OK
]
.
-
--
-
ECM (Error Correction Mode)
This feature automatically sends data
that wasn't transmitted successfully
again using a technique called ECM,
an internationally recognized proto-
col (requires that the destination ma-
chine has the same feature).
Note
❒ By default, ECM is on. You can
turn it off. ⇒ P.178 “ECM”
Transmission Result Report
(Immediate Transmission)
If you turn this report on, a report will
be printed after every Immediate
Transmission so you have a record of
whether the transmission was suc-
cessful or not. If the machine is set up
not to print this report and the fax
message could not be successfully
transmitted, the Error report is print-
ed instead.