Filter
Top Products
Remote Maintenance by Telnet (mshell)
61
5
❒
The Network Interface Board is reset automatically when the settings are
changed.
❒
When the Network Interface Board is reset, the active print job which has
already been sent to the printer, will finish printing. However, jobs that ha-
ven't been sent yet will be cancelled.
Command List
This is a list of commands that can be used via remote maintenance.
Note
❒
Input “help”, to see a list of commands that can be used.
msh> help
❒
Input “help command_name”, to display information on the syntax of that
command.
msh> help
command_name
TCP/IP Address
Use the ifconfig command to configure TCP/IP (IP address, subnet mask, broad-
cast address, default gateway address).
❖
Reference
msh> ifconfig
❖
Configuration
msh> ifconfig le0
parameter
address
The following is an example for configuring an IP address of 192.168.15.16.
msh> ifconfig le0 192.168.15.16
The following is an example for configuring a subnet mask of 255.255.255.0.
msh> ifconfig le0 netmask 255.255.255.0
Note
❒
This affects the configuration of the Network Board of the IP address that is
used.
❒
To input an address using hexadecimal, add “0x” to the first command.
Parameter Configuration Item
(no parameter) IP address
netmask subnet mask
gateway default gateway address