Filter
Top Products
Message List
75
5
Message List
This is a list of messages recorded to the printer's system log. The system log can
be viewed using the syslog command.
System Log Information
You can use the following methods to view the system log.
• mshell : Use the syslog command
⇒
P.65
“System Log Information”
.
• Network Configuration Page : Configure PCL for the Printer Language, and
push the switch on the Network Interface Board while five seconds
⇒
P.84
“Network Configuration Page”
.
Message When the Network Interface Board Starts or Restarts.
RICOH Network Interface Board
Ver.x.x.x
The version number of the Network Inter-
face Board.
PRINTER SYSTEM “system name”
Ver.x.x.x
The system name and version of the print-
er.
Attach FileServer=“file server name” The printer is attached to “file server
name” as the nearest server.
Current Interface Speed:xxxMbps The speed of the network (10 Mbps or 100
Mbps).
Current IPX address The current IPX address.
Frametype=“frame type name” The "frame type name" is configured to be
used on NetWare.
NetBEUI Computer Name=“computer
name”
The NetBEUI Computer Name is defined
as "computer name".
Start httpd The Web server has been started.
Start npmpd for IPX The npmpd for IPX protocol has been
started.
Start npmpd for TCP/IP The npmpd for TCP/IP protocol has been
started.
Start smbd direct print mode(NetBEUI) You can print from a client on the Win-
dows network via the print server.
Start snmpd Ver.2.0 The SNMP agent of the displayed version
has been started.
Vendor= , Country= , Lang= The vendor, the country code, and the lan-
guage.