Filter
Top Products
Windows NT 4.0 Configuration
16
2
Preparing to Use the TCP/IP Protocol for Printing
Follow these instructions to configure the Network Interface Board and Win-
dows NT to use the TCP/IP protocol.
Configuring the Printer
Configure your printer to use the TCP/IP protocol.
• Confirm that the TCP/IP protocol is set to be active. (The factory default is ac-
tive)
• Assign an IP address and make other settings required for using the TCP/IP
protocol.
Reference
For more information on how to make the above settings, refer to the Operat-
ing Instructions for your printer.
If DHCP is used to assign IP addresses, refer to P.82
“When Using DHCP”
.
Note
❒
After setting the IP address, use the PING command to confirm that it has
been set correctly.
A
Click
[
Start
]
, point to
[
Programs
]
, and then click
[
Command Prompt
]
.
B
Input the following. (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured correctly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.