Filter
Top Products
Configuring Windows 95/98
9
1
B
Configure the TCP/IP protocols with the appropriate IP address, subnet
mask and other settings.
Confirm with the network administrator that the settings are correct.
Preparing to Use the NetBEUI Protocol for Printing
To use the NetBEUI protocol to print, the network must be configured as de-
scribed below.
Configuring the Printer
Configure your printer to use the NetBEUI protocol.
• Confirm that the NetBEUI protocol is set to be active. (The factory default is
active.)
Reference
For more information on how to make the above settings, refer to the Operat-
ing Instructions for your printer.
Configuring a Windows 95/98 computer
Install the NetBEUI protocol into a Windows 95/98 computer, and configure
NetBEUI as the default protocol.
A
Double-click the
[
Network
]
icon in the
[
Control Panel
]
, and confirm that “Net-
BEUI” is in the
[
The following network components are installed
]
list of
[
Configura-
tion
]
tab.
Note
❒
If NetBEUI is not installed, click
[
Add
]
of
[
Configuration
]
tab, and install it.
For more information, refer to the Windows 95/98 online help.
B
Configure the NetBEUI protocol as the default protocol. Click the
[
Configu-
ration
]
tab, select “NetBEUI” in the
[
The following network components are in-
stalled
]
list, and click
[
Properties
]
C
Click the
[
Advanced
]
tab, select
[
Set this protocol to be the default protocol
]
, and
click
[
OK
]
.
D
Click
[
OK
]
, to close the
[
Network
]
dialog.
E
After confirming the message to restart, click
[
Yes
]
.