Filter
Top Products
Sending a Fax Message
46
2
TRANSMISSION FEATURES
Stamp
When sending a fax message using
the Document Feeder (ADF), the ma-
chine can stamp a circle mark at the
bottom of the original. This stamp in-
dicates that the original has been suc-
cessfully stored in memory for
Memory Transmission, or that it has
been successfully sent for Immediate
Transmission.
Limitation
❒ Stamp only works when scanning
from the Document Feeder (ADF).
❒ While scanning the document, you
cannot switch stamp on or off.
❒ Do not open the document feeder
(ADF) while scanning the docu-
ment. Document jam should occur.
Note
❒ When the stamp starts getting
lighter, replace the cartridge. ⇒
P.197 “REPLACING THE STAMP
CARTRIDGE”
❒ If a page was not stamped even
though the Stamp feature is turned
on, you need to re-send that page.
❒ By default, Stamp is turned off. If
you use this feature often, you can
adjust the User Parameters so that
the home setting is on. In this case,
Stamp can easily be turned off for
any single transmission by press-
ing the {
Stamp
} key. ⇒ P.184
“Changing the User Parameters”
A Press the {
{{
{
Stamp
}
}}
} key.
The Stamp indicator will light.
Pressing the {
Stamp
} key again
will turn Stamp off.
Closed Network
This feature allows you to restrict
transmission of messages only to ma-
chines of the same make, and only to
those machines that have the same
Polling ID. The transmission options
let you switch ID transmission on and
off for each separate transmission.
Note
❒ The default setting is off. Turn this
feature on with the User Parame-
ters. ⇒ P.184 “Changing the User
Parameters”
F Code (SUB)
Normally you can only use Confiden-
tial Transmission to send to fax ma-
chines of the same make that have the
Confidential Reception feature. How-
ever, if the other machine supports a
similar feature called “F Code”, you
can send fax messages to the other
party using this method instead.