Filter
Top Products
NetWare Configuration
32
3
NetWare 3.x - Advanced Settings
The actual procedures for configuring your printer differ depending on whether
the Network Interface Board is configured as a print server or as a remote print-
er. This section describes how to configure it in the NetWare 3.x environment.
Preparation
The following procedures use the Property Sheet method in configuring the
Network Interface Board. If you configure the Network Interface Board as a
NetWare print server for the first time after physically installing it, we recom-
mend you use the Wizard method. For more information, refer to P.29
“Quick
Setup Using the NIB Setup Tool Wizard”
.
Note
❒
This section assumes NetWare is functional and that the necessary environ-
ment for the NetWare Print Service is available.
Setting Up as Print Server
A
Log in to the file server as a Supervisor or a Supervisor equivalent.
B
Run the NIB Setup Tool.
Reference
“Running the NIB Setup Tool”
⇒
P.28.
C
Click
[
Property Sheet
]
and click
[
OK
]
.
The Browse dialog of the Network Interface Board appears.
D
Click
[
IPX protocol
]
.
Installing the NIB Setup Tool
Print Server Remote Printer
Basic Procedure
Configuring the Network Interface Board
Configuring the NetWare
Turning the power
off and on
Start the print server