Filter
Top Products
Sending a Fax Message
26
2
Limitation
❒ Standard Memory Transmission is
used instead of Parallel Memory
Transmission in the following cas-
es.
• When the line is busy and could
not be connected to
• With Send Later
• With Transfer Request
• When you store an original for
Memory Transmission while
another communication is in
progress
• When two or more destinations
are specified
• When you send just an Auto
Document
• When the original is set on the
exposure glass
• With the image rotation
❒ If you press the {
Clear/Stop
} key,
the original jams, or memory be-
comes full during Parallel Memory
Transmission, the machine stops
transmitting and prints the Trans-
mission Result Report (Memory
Transmission). The file is erased.
❒ Total stored page numbers are not
printed in the Parallel Memory
Transmission. Only the page num-
bers are printed, such as P.1, P,2
not
1
/
2
,
2
/
2
Note
❒ If you run out of memory, normal
Memory Transmission takes place.
When and if this happens varies
depending on the various options
you have installed.
Memory Storage Report
This report is printed after an original
is stored in memory. It helps you re-
view the contents and the destina-
tions of stored originals. Even if the
machine is set up not to print this re-
port, it is still printed if an original
could not be stored.
Note
❒ You can turn this report on and off.
By default it is not printed. ⇒ P.184
“Changing the User Parameters”
❒ You can choose whether to include
part of the original image on the re-
port (part of the image is printed
by default). ⇒ P.184 “Changing the
User Parameters”
Transmission Result Report
(Memory Transmission)
This report is printed when a Memo-
ry Transmission is completed so you
can check the result of the transmis-
sion. If two or more destinations are
specified, this report is printed after
the fax message has been sent to all
the destinations. If the machine is set
up not to print this report and the fax
message could not be successfully
transmitted, the Communication Fail-
ure Report is printed. ⇒ P.27 “Com-
munication Failure Report”
Note
❒ By default this function is turned
on so you need to turn it off. ⇒
P.184 “Changing the User Parame-
ters”
❒ You can choose whether to include
part of the original image on the re-
port (by default, part of the image
is printed).⇒ P.184 “Changing the
User Parameters”