Filter
Top Products
SCAN SETTINGS
37
2
ty yourself, use Manual Image Densi-
ty.
Auto Image Density
The machine automatically selects an
image density which is the most ap-
propriate for the original.
By default, Auto Image Density is se-
lected when the machine is turned on
or modes are cleared. You can change
this with the User Parameters. ⇒
P.184 “Changing the User Parameters”
A If the Auto Image Density indica-
tor is not lit, press the l
ll
l key to
turn it on.
Manual Image Density
Use the Image Density keys to vary
the image density within 7 levels.
A Make sure that the Auto Image
Density indicator is not lit. If it is
lit press the l
ll
l key to turn it off.
B Press the i
ii
i or j
jj
j key to change
the density. The indicators above
the keys show the level.
Mixing Scan Settings in a
Multiple Page Original
When sending an original consisting
of several pages, you can select differ-
ent Image Density, Resolution and
Original Types for each page.
Set your original, select the scan set-
tings for the first page, dial and press
{
Start
} as you would normally. Then
follow one of the following two pro-
cedures.
When Setting Originals on the Exposure
Glass
While the machine is bleeping, you
have about 60 seconds (10 for Imme-
diate Transmission) to select density,
resolution and original type. The re-
maining time is shown on the display.
A Check the pages you wish to
change the setting.
B Remove the previous page and set
the next page.
C Select the Image Density, Resolu-
tion and Original type.
Note
❒ You adjust settings for each
page before you press the
{
Start
} key.