Filter
Top Products
XSCF>
showstatus
XSCF>
showhardconf
Note -
Use the DR of the system board on a physical partition for active/cold maintenance.
For the XCP and Oracle VM Server for SPARC/SRU versions that correspond to the DR, see
the latest Product Notes.
Note -
Active/cold maintenance can be performed only for a building block configuration.
Note -
In the case of a dual power feed, connect the power cords in their original positions by
referring to the record that you made before the start of maintenance.
11.6.1 Active/Hot maintenance
1.
Return to the operation of the XSCF firmw are replacefru co mman d to confirm
that th e fan u nit has b een incorporated into the syste m.
For details, see "6.1 Incorporating an FRU into the System with the replacefru
Command."
2.
Execute the sho w status command to confirm t h at there is no problem with
the f an unit after the co mpletion of mainten ance.
3.
Execute the sho w hard conf command t o check the hardware confi guration
and t h e status of each component.
4.
Close t h e rack d oor.
11.6.2 Active/Cold maintenance
1.
Connect all the po wer c ords to the PSU backplane unit of t he chassis
requiring maintenance.
For details, see "6.5.1 Installing the power cord."
2.
Return to the operation of the XSCF firmw are replacefru co mman d to confirm
that th e chassis has been incorpor ated into the system.
For details, see "6.1 Incorporating an FRU into the System with the replacefru
Command."
3.
Incorporate t he chassis, in which the fan unit requiring maintenance is
mounted, i nto the ph ysical partition.
For details, see "6.2 Incorporating a Chassis into a Physical Partition."
4.
Close t h e rack d oor.
Chapter 11 Maintaining the Fan Units 215