Filter
Top Products
Note -
For a building block configuration, press the power switch on the master chassis. The
power switches of the other chassis are disabled.
Note -
For a building block configuration, check the POWER LEDs on all the chassis that
make up the system.
3.
Check that the P OWER LED o n the operation panel is o ff.
5.5 Accessing Components
This section describes the operations that must be completed prior to accessing a
component requiring maintenance.
5.5.1 Lowering the cable support
For a component that is accessed from the rear of the SPARC M10-4/M10-4S, the
cable support must be lowered and then the cables removed.
1.
Loosen the right and left screws f ixing the c able support, an d unlock it by
pulling the up per a nd l ower metal fittings towards you ( in t he d irection of t he
arrow).
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
December 201364